Why FUELAP is better than any other economizer?
Because FUELAP specially has been designed, extending the areas of influence of the magnetic field by on the passage of the fuel, which generates a better reordering of molecules of the same one. In general all the economizers use small neodymium tablets (çm Ø), which generates a high level of magnetism, but in an area of work very reduced. After different studies, one has demonstrated that using magnetized segments of greater surface (5 x 4.5 cm) that the neodymium tablets, better results are obtained, because the work area is greater.

With FUELAP I can use fuels of any octane?
Indeed, it works with any type of fuel and octane.

It also works in equipment with GNC?
It also  works in GNC equipment.

Why the manufacturers of automobiles do not incorporate FUELAP in series?
This question would have to answer it the own manufacturers. It can have many reasons, some of them can be that being a relatively new discovery, and although very few new models in the world already bring it built-in, the great majority of our vehicle park does not have it.
In any case the FUELAP has been a new application of a principle discovered for many years.
In fact General Motors already would have patented a very similar system in the USA.

Where it is possible to be installed?
FUELAP can be installed as much in any vehicle (automobile, motorcycle, boat.) of Super, Normal gasoline, with or without lead, oil Gas and even GNC. Also in any type of Industrial Machinery, Generator Electronic.

Can I install it by myself?
Of course that yes. FUELAP does not require of any technician. You can install it in 5 minutes, without special tools, and without to cut nor to alter nothing in your motor.

How to verify the FUELAP yield fuel?
In the first place, be sure to verify the amount of kilometers made by fuel tank well before installing FUELAP.
After installing FUELAP it returns to load his fuel tank, and writes down the crossed kilometers. It will notice the difference.

Why he is more effective to place it more close possible to the carburetor or body injector?
The fact to place it more close possible is for avoiding possible later turbulence's, produced by any accessory that could take the vehicle (for example gasoline filters or unions of the conduit of fuel supply). These turbulence's could also reduce the effect of the magnetic field, returning the fuel to their state previous to the passage by the FUELAP.

When is obtained the best yield of the FUELAP?
The best yield will be noticed as soon as of the first 3 fuel tanks, since as of that moment the fine coal deposits will have been eliminated, and their carburetor or injector will be in better conditions of operation.
The percentage of economy change depending on the vehicle, its use (in route or city), their suitable location, and of the engine power.